★ StatTrak™ Falchion Knife | Doppler (Factory New) Phase 3

Skin overview

★ Falchion Knife | Doppler (Phase 3) is a curved clip point knife covered in a deep blue candy finish with violet clouds and dark green-teal patches. In Factory New the coating is at its glossiest, so the marbled transitions look wet and the colours stay saturated from tip to pommel. This is the grade for buyers who want the finish exactly as it was designed.

Item type: knife. Covert is the top weapon rarity: usually the most prominent items of a collection or case.

Anodized Multicolored: several colours in the metal coating; it wears little, the colours only dull with use.

The remaining qualities of this skin: Minimal Wear.

Appearance in Factory New

The blade carries the full candy-coated marble: rich blue with violet clouds, darker teal-green zones and black veins, while the sharpened edge and spine show a thin line of bare steel. The handle continues the same marbled colour, framed by a flat grey steel bolster plate with screws near the blade and a metal liner at the curved pommel.

The candy coat is unbroken across the blade, spine and handle. The tip and the edges of the finger grooves keep their colour without any pale spots. In game the knife looks glossy and evenly saturated at any distance. Only the steel bolster, edge and liner show metal, as intended by the design.

Factory New quality — float range 0–0.07

The whole float range of ★ StatTrak™ Falchion Knife | Doppler Phase 3 is 0–0.08; Factory New takes the 0–0.07 segment (88% of the scale). Within the range, copies with a lower float look cleaner and are valued higher.

Origin of the skin

It drops as a rare special item from:

• Spectrum Case
• Spectrum 2 Case

StatTrak™ version

This is the StatTrak™ version: the counter on the weapon shows confirmed kills. There is also the regular version without the counter.

What to look at before you buy

• Look at the pattern on both sides of the blade, since the balance of blue, violet, green and dark areas differs between copies.
• For Minimal Wear, inspect the blade tip and spine, which lose coating first.
• Check where the float sits in its wear range, as a low float in Minimal Wear looks close to Factory New.
• Note whether the knife is StatTrak™ or carries a name tag, if that matters to you.

Who the Factory New quality suits

• Collectors who want the candy finish without a single mark.
• Players who inspect their knife often and want the cleanest gloss.
• Conclusion: the choice for a flawless Phase 3.