—
★ StatTrak™ Shadow Daggers | Gamma Doppler (Factory New) Phase 3
- Type
- Knife
- Weapon
- Shadow Daggers
- Rarity
- Covert
- Other category
- Regular
Offers 0
No offers available
Similar skins
Show allAll
Skin overview
★ Shadow Daggers | Gamma Doppler (Phase 3) is a pair of push daggers in a multicoloured anodized finish, with bright green handles and blades marbled in cyan, teal and green. In Factory New the candy coat sits evenly over both daggers, so the colour transition from handle to blade stays smooth and saturated. This is the grade for buyers who want the phase colours exactly as they were applied.
Item type: knife. Covert is the top weapon rarity: usually the most prominent items of a collection or case.
Anodized Multicolored: several colours in the metal coating; it wears little, the colours only dull with use.
Other qualities of this skin: Minimal Wear.
Appearance in Factory New
Both daggers share the same scheme: the handles with their large cut-out finger openings are coated in a bright, glossy emerald green. The green flows down the guard into the blades, where it turns into light cyan and teal with cloudy marbling in green, white and pale blue.
Factory New copies show no visible wear on either dagger. The green handles keep a uniform gloss, and the marbled cyan blades stay sharp in their colour transitions right up to the tip. In game the daggers read as clean and bright from every inspect angle. Higher floats within this grade can still hide tiny marks at the very tips, but they are only found when looking for them.
Factory New wear: float 0–0.07
The float of ★ StatTrak™ Shadow Daggers | Gamma Doppler Phase 3 ranges from 0 to 0.08; the Factory New quality covers 0–0.07 — 88% of this skin’s scale. Within the range, copies with a lower float look cleaner and are valued higher.
Where the skin comes from: collection and case
It drops as a rare special item from:
StatTrak™ version
This is the StatTrak™ version: the counter on the weapon shows confirmed kills. There is also the regular version without the counter.
What to look at before you buy
- Inspect the blade tips and edges first, since that is where the coating wears away earliest.
- Check the outer rims of the handles and the edges of the finger openings for small scratches.
- Compare the float position within the grade, as a low-float Minimal Wear and a high-float Factory New can look very similar.
- Look at the screenshots to see how much green versus cyan this copy shows on the blades.
Who should buy Factory New
- Collectors who want the Phase 3 colours with no compromise.
- Players who often inspect their knife and notice every mark.
- Conclusion: the choice for a clean, complete copy of this phase.
